HAGE E-Charging Station XEV151S7035 M3 3-phase 32A + M2 16A

E-charging station witty home 1x22kW 3P M3T2 M2TF IP54. Wallbox charging station with UV-resistant plastic housing for charging electric or plug-in hybrid vehicles. Charging mode 3 according to EN 61851 or charging mode 2 or 1 for direct charging via a Schuko socket, protected by the charging station supply line. Charging station with Mode 2 Schuko socket 16 A and direct connection for charging cable (cable not included). Permanently installed charging station for indoor / outdoor use, free use without access authorization, for direct connection of charging cables and suitable for the type of vehicle connector. Consists of wall housing with cable holder and connector shelf, cable entry for the supply voltage, cable entry for charging cable, charging button and LED displays. Electrical protection / switching control consisting of power supply unit, line circuit breaker, charge controller, current measuring coil, installation contactors and feeder terminals. The micro-controlled charge controller (charge current adjustable max. 32 A) communicates with the vehicle and controls the charge. The status displays are via green LEDs: LED bar ready for operation (flashing), immediate charging (LED bar pulsating), night charging (delay with round LEDs or charging with LED bar pulsing) and fully charged (LED bar continuously lit). Switching between delayed and immediate, automatic charging is possible by pressing a button. The start of charging can be started externally via a release contact (230V AC switching signal). With an optional charging control module, the charging current can be adapted to the available free capacity of the house installation or use for the targeted charging of regeneratively generated energy (PV, CHP). The power supply for the charging station must have a separate circuit. The connection of several charging stations to the same circuit is not permitted. Each charging station must be installed with a separate FI circuit breaker (RCD) and line circuit breaker (MCB), e.g. in the distribution cabinet. The charge controller must be configured before it is used for the first time. Notes: The charging station can be operated 1-phase or 3-phase. Only use compatible Hager mode 3 charging cables with plug or coupling and open cable end (charging station side). Parallel charging with different charging modes is not possible. Optional stand with base for free-standing assembly.